It is not the jetdrive yet. I wanted to test with the propeller/duct drive first. I am going to assemble the and test the battery pack then. I assume my ride time and efficiency will be less and more noisy.
At the moment I am enjoying my music while I ride 
Are you in the States? I can ship one to you. The vent.
Hi! I am in washington state. And that would be very generous of you!
@Vincentbraillard. Thank you for the link.
I hope this will help vent the heat from my battery pack.
Hi @V_S
I did some paper trail research and I found out that my cells are 21700 and rated at 5000mah.
That makes sense.
But i guess 5AH only in paper. Usually they have 3-4AH (21700)
Hi Mauiman,
You will share files of 3d printed files of this jet drive set up?
Thanks
Giacomo
Yes eventually after I get it working.
Really impressive. Nice one
Wishes for your child, but the jet child is growing?
Thanks! yes, the jet child is still growing. I had to design a new motor mount because the previous one was too short for my shaft coupler and sealed bearing so I decided to move the coupler to the outside of the motor mount.
Nice video, which drone is that? But you are not using your jetdrive, correct?
I am using the Airdog. But the lowest it can fly is 5M. I have to use the mavic if I want a low flying water shot.
Correct, no jet drive yet. Waiting for a free weekend to assemble the new motormount.
Excited to see how it runs in the water!
Would you share your impeller as .stp file? I downloaded already the .stl file. I want to try your impeller in my propulsion, but i need to make a modification for the mounting screw. Fusion 360 can not convert the stl 
Sure! I will convert when I get back in town.
Looking mint! Good luck for your water tests.
