I bought a used windsurfing board with a standard Tuttle box in it. Dimensions are 240cm x 95cm, displacement 210L. Oh, and the Tuttle box is located quite far back, maybe 20cm from the back edge of the board. Any red flags?
My next step is to buy a mast, cut some holes in it and figure out how to 3D print an enclosure for a motor. I don’t think I even need wings at this stage, hoping to just have a mast with a motor on it working for starters and use it as an eSUP.
It looks like there aren’t many standard tuttle => plate converters, but I found a few brand specific tuttle adapters. This is the most promising approach so far:
Does this seem like a good idea? Are mast cross-sections standard dimensions? Or are they all different and non-interchangeable?
Thanks for your wisdom,