Shared. I am tempted to add that this pull setup is not present in the 6 patents I’ve read so hopefully cannot be patented now.
Haha! I love that fact
Foil to the people!!!
I see some issue though as it will act as a perfect sea weed and plastic bag hoover.
You may design some front triangular prop cage to have obstacles diverted before reaching the prop, a bit like a locomotive front shield
If I acctually get to the stage were I am able to cut sea weed I will consider it a win
Made a prototype for water proofing my XT150 connectors that will be placed between the mast and the board. I use two lip seals 4x12x6mm and a o-ring 19.5x3mm togheter with a 3D-printed shell with threads. Its a very tight fit for my 10Awg wires. I used a bit of oil in order for the shell to “spinn” on the wires. I think 4,5mm would have been better but i didnt find any.
There is no room for the plastic covers that come with the XT150 inside the housing.
I will add the STL if the overnight test is successfull.
Looks great! Clever to use shaft seals to rotate on the wires. Perhaps a radial o-ring groove could remove the threads and give a good seal as well.
We will use that design it is a great idea, thank you for sharing.
great idea, I like that. Thank you for sharing
100% dry after 10 hour at 15cm depth.
Here is the STL.
https://1drv.ms/u/s!AiqyEh4Sf4KAhoB8QOKlyqunB939fA
You will most likely have to do a little sanding to get a smooth feeling in the thread. I added a layer of clear coat to the 3D part as well.
Enjoy!
Hmm, yes that would make it much easier and faster to print. Threads are demanding and requires some after prep to work in a good way. I like the lip seals. Thinking about using the on the “board side” as well. 3d print a “wall” with three pockets for lip seals. Epoxy the wall to the board and you have a water tight cable gland that requires minimum space.
Battery update!
I’ve CAD:ed, printed and tested.
First 6s pack is now done. 42,5ah cells from sk innovation. They are found in the car Kia Soul.
Frame in PLA. Surface of cells protected with 1mm rubber. Everything is wrapped in a gigantic heat shrink tube.
Looks Good!..
Looks like a nice battery package!
What are the completed battery dimensions?
What cells are you using and cost?
Cells are second life cells coming from a Kia soul. Each cell is 130x310x10mm and the weight is 750gram. I bought 12 pieces for approx 300 euro.
where did you buy them?
From your local car scrap yard. I don’t think you can buy them “new”.
42Ah 12S for 300€. I admire your scrapyard negotiating skills
Weight is 5086 grams.