Hi, very excited to start my buld, hope could learn and could contribute in this comunity. I have knowledge en 3d desing, printing, cnc, rc and fpv uavs.
3 Likes
Hi and welcome, what design where you planning to build?
Hey, Well I think going to do with the @pacificmeister proposal. I would like to make the greatest quantity of components by my own. I just started ordering the electronics.
Hello,
I have my electronics ready to set. I haven’t experience with surfing. Looking by Facebook found this board for U$ 100. Could it work?
[image|375x500]
(upload://zbAlG6P2p5TEn83iCBS3aJ23KZp.jpeg)
I’d say it is a bit too short and way too thin. I would aim at 150 - 190cm and around 80L of volume. It should be at least 10cm thick for enough volume and to hide some of the electronics.
1 Like