Looking for STL file for 65150 FR prop fairing

Flightjunkie · December 28, 2019, 7:21am

No worries. For now I just made this one fit.

Darby · December 31, 2019, 11:24pm

This STL does not fit the Flipsky motor…

Flightjunkie · December 31, 2019, 11:35pm

Yea. I had to modify it as depicted above. I’m terribly slow with fusion 360, so this was faster for now. I will post the modified STL if and when I get around to it.

But, it’s not hard to make fit. Took me all of 10 minutes.

Darby · December 31, 2019, 11:45pm

Ok thanks- I’m modifying mine now… looking forward to the new print.

Beninspain · June 4, 2020, 1:10pm

Did you ever get round to doing this for the maytech 12mm shaft?
Im about to reprint one in PC max, wondered if i still have to modify this with my dremel?

Flightjunkie · June 4, 2020, 4:53pm

@michion edited the two files. I’ll have to look for the post.

…here you go!

Thanks again Michion!

Beninspain · June 4, 2020, 5:17pm

Thankyou. Knew I had seen it somewhere.

philippe · September 26, 2021, 3:12pm

Hello
Do you have the “360 fusion” file for the Flipsky 65161 motor duct, thank you