Hello,
need your advice to choose my sss 56114 in combination with the reducer NEUGART PLE 40/5: 1 …
360 kv or 500 kv …
I admit to being a little lost, less Kv more torque certte but the reducer will not you have too much impact on a low kv engine … ??
thanks for your advices.
**mast clamp:**PG7 cable glands placed and silicone on the thread, we will let dry and test … I cross my fingers … carene: reception of the high density foam block with rail us box of home gong … the router will purr …
@Manu Looks like you and I are at about the same place and doing the same builds. Maybe we can help each other. Did you have a machine shop make your shaft coupler? And is there any wobble or vibration at the prop end?
hello @sunrise305 alas no I do not have a CNC or turn to machine but a friend on Nice city has his factory … about the tree I have not tested yet … we will see the first test … .
I here is the link thingiverse for the mast clamp for efoil GONG ALLVATOR: https://www.thingiverse.com/carvalhoemmanuel/designs
got the o-rings and am trying to trison the tight junction tube and mast clamp …
I had actually thought, I’ll wait to receive the engine to cut the final length of the aluminum tube and I would see at this time if there is too much scope.
Ah…no engine in there yet. I ended up not cutting my tube at all so it could house wires long enough to completely slide the motor out the back. The front of my tube is permanently sealed.
My tube is 12 inches (304mm). Some have mounted the duct directly to their foil for added support as shown here. I wanted to keep the water flow in that area clean (less prop wash) so raised mine a bit. And in terms of the prop being directly above the rear foil or in front of it, there are many examples on this site of both. Not sure if either makes a difference.