Very nice XT90 waterproof shield. I have a few questions:
how is it going after 6 months of use ? Is there anything you would like to modify ?
which 3D printing material did you use ?
can the model be enlarged to receive XT150 connectors ?
Thanks.
If you want an earlier take-off, just place 1 to 4 layers of soda plastic bottle material (cut like washers) around the rear screw of the stab between the fuse and the stab. This will create more downward lift at the stab level when you take speed therefore a faster nose up for the front wing therefore for the whole foil…
I printed your waterproof connector for XT 150 and the result is good. Only note: I find that the hose fits too easily and does not have enough resistance to be waterproof… do you put COLSON type clamps to tighten the tube on the connector?
Thank you.
i dont use colson type clamp, in my case resistance is high.
it can be a good solution.
you can try to increase external diamter of connector ?
somebody advice me to use silicone pipe to be more “waterproof”
This would have been a solution indeed, but as I didn’t have the file in 360 fusion format I ordered a 9x12 pipe instead of the 10x14…
For the moment I’m just using it to connect the negative pole between my battery in a separate compartment from my ESC compartment.
I would like to do the same for all three phases in order to be able to disengage the mast from the board.
Bonjour à tous ! Félicitation pour vos travaux ! J’ai uploadé le projet il y a de ça quelques mois et je me suis mis à vouloir le produire. Avant cela j’ai analysé un petit peu votre système pour peut-etre l’ameliorer et suis arrivé à quelques conclusions que j’aimerai que vous validiez par votre expérience. Vous êtes partant ?
Hi @Guillaume you cannot post a private message at the beginning of your registration, you need a certain seniority before accessing this function. And a piece of advice: post in English because some members will not hesitate to send you a private message at reprendre😉.